Manufacturing
-
Manufacture of a PVC photo box
- By Tony Lombard
- On 05/05/2021
- In Facilities and materials
To take beautiful photos of your zebrafinch, here is a photo box model to make yourself.
1. Materials needed
- White PVC panel, 5 mm thick.
- PVC U-shaped slides.
- PVC angles in L.
- 1 ultra-flat neon with switch.
- Trunnion Ø 10 or 12 grooved.
- Silicone glue.2. Cutting the PVC panel
- The PVC panel is cut to form a cube with the following dimensions: Length 38 cm, depth 32 cm, height 32 cm.
- On a wall, a hole 6 cm in diameter (to be adjusted according to the lens of your camera) is made at the height of the future perch.
- On another wall, an opening 10 cm wide by 12 high is made for the sliding door which will allow the bird to be introduced into the box.
- Cut 1 door to close the hole which will be used to photograph the bird (example of dimensions for a 6 cm hole: 10 cm x 10 cm).
- Cut 1 door of 12 cm x 14 cm for the opening that will allow the bird to be introduced into the box.
- Cut a 10 cm x 10 cm square that will serve as a base for the perch.
3. Gluing the slides
- Cut and glue 2 guides (U-shaped angles) which allow the door to slide, which can block the Ø 6 cm opening.
- Cut and glue 2 slides (U-shaped angles) which allow the door to slide, which will be able to obstruct the opening 10 cm wide by 12 cm high.
